In this guide, we'll walk you through the initial steps to set up and wire your PoE NVR.
Wiring and Initial Setup
If you connected your NVR to an HD-TV, you will see the following message after booting up:
Click OK to have your NVR's output resolution optimized.
If you click OK, and the overall image has improved, click OK again to save the settings. However, if the image has been degraded, click Cancel to revert back to the original quality.
Tip: You can manually adjust the NVR output by logging in and navigating to: Setup > System > General > Output Configuration
Be sure to adjust the output to your HDTV's resolution capabilities.
To Login, Click anywhere on the screen, then click the bottom left-hand icon, then setup.
Default password is: admin789
